![]() Connect phone.ġ4: This time the flashing will begin. For example, "LGUP_VS995.dll" for VS995 variant )ġ3: Now select that extracted dz in S/W section this time. (You need different dll for different model. This time Select LGUP_H990ds.dll this time for dll section Just disconnect it.ġ2: Now exit and start LG Flash Tool again. kdz visible).ġ1: Now Begin downloading by pressing "Yellow Right Arrow". kdz in S/W section (You will have to select show all files to make. You will notice a dz and LGUPc.dll.Ĩ: Run LG Flash Tool. Select all content off kdz.ħ: Click on extract kdz. Change COM Port to 41.Ĥ: Extract LG Firmware Extract and copy Stock KDZ to that folder.ĥ: Run WindowsLGFirmwareExtract.exe. Wait until it finishes installing drivers. (Hold Vol+ and connect to PC while it was powered off). So it has no problems with new Windows OS. I tried this process many times on Windows 10 64-bit and it always worked for me. Uninstall all other tool, previous driver (including other phone’s too). You need to download KDZ of your specified model.ħ: Dll specified for your model (in 2nd post H990ds dll is provided) (All above files can be found in 2nd post) In that way you can save a lot of time.Ĥ : LG Flash tool (the one used to bring LG G2, G3 back to stock). And now you can’t bring it back to life.īefore asking a question, first, see FAQ in 3rd post. You want to go back to stock and can’t do it.ģ: Anything bad happened during flashing process, PC restarted, phone went off or whatever. Possible cases:ġ: LG V20 stuck on download mode and it is now not being recognized by LGUP and you can’t do anything, because no other tool is available.Ģ: You installed a custom ROM and now LGUP is not recognizing it. You need files respective for your model. So, we were able to do this process and it worked finally. We tried different ways, different drivers but all in vain. Phone was unable to go pass LG logo and boot. I had a friend who tried to root his H990ds with dirtysanta but due to some issues the whole process messed and his phone was struck in download mode. This usually happens when you try to root with dirty and do something wrong to mess up entire process. Now you have successfully installed LGUP Tool on your PC.Did you got that annoying "Unknown Model" in LGUP and now are struck download mode. After the above step, wait for the installation process to complete and then finally tap on Finish.And then on the next screen, Agree to the LG Terms and Licence agreement and click Next.This is where you will actually install the LGUP Tool. Double-click on the LGUP_Store_Frame_Ver_1_14_3.msi file next. ![]() Wait for a couple of minutes before proceeding to the next step. You will simply see a pop-up window for a moment and then it will be gone. Please note that there is no UI for this installation. Double-click on the LGUP_8994_DLL_Ver_0_0_1_18.msi first and install the same.Download the LGUP Tool Zip file from the downloads section above and extract the same.Installing the USB Driver is important as the tool will not even start if you do not install the USB Driver properly. Make sure to install the LG USB Driver on your Windows PC before proceeding.Follow the below steps carefully so that you can have an error-free firmware flashing experience on your LG Android device. To have a smooth experience with the LGUP Tool, it is imperative that you install the tool properly. LG Uppercut Tool How to Install LGUP Tool
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |